Compound hinge system allows the lid to swing out and completely around to lie flat against the main body of the case, or you can go lid-less with an effortless lift motion and reinstalled with the same ease in seconds.
The front and rear lids are designed to protrude into the base of the case approximately 1" making the case incredibly strong. Doors are fitted with rubber gaskets for water resistant protection. Significantly fewer latches than most competition allows for rapid deployment in an up-right configuration -- even when stacked. Meets most ATA and military specifications.
The new SKB Roto Shock-Rack Cases stack securely with the wheels on or off and this revolutionary design is also the only shock rack that will open front and back while stacked. Other features include black powder coated stainless steel latches, removable 4" casters, eight elastomeric shock absorbers (load range of 40 to 150 lbs.) with provisions to add additional shocks for an extended payload range to 300 pounds (3SKB-SA), gasketed doors and pressure relief valve.
Equipped with square-hole rack rails to accommodate either #10-32 US standard, or 6mm International standard cage nuts which are supplied with the cases. Standard 19” rackmount width per EIA standards. The depth front to rear rail is 24" (measured from outer face of the front rail to outer face of the rear rail) and each lid is 4.5" deep. A standard Rack Unit is 1.75 inches (4.445 cm) in height.
All SKB 24" Roto Shock Rack Cases (3SKB-R904U24, 3SKB-R906U24, 3SKB-R908U24, 3SKB-R910U24, 3SKB-R912U24, 3SKB-R914U24, 3SKB-R916U24) come with SKB's Million Mile Warranty. If your case breaks, it will be repaired or replaced at no cost to you. SKB cases have been on the road for 30 years, standing up to the toughest military and industrial conditions.
Rackmount Tips and Tricks
Click on Part # below for specifications.
ASK ABOUT QUANTITY DISCOUNTS